 Vivid Vinyl Flower Necklace
Designed by Ashley Bunting
These new upcylced vinyl flower mixes are awesome! They work great with metal and lucite flowers. They come in an array of bright colors, earth tones and metallics. Stack small, medium and large flowers together to make a fun, multicolored flower with great texture. The flower stacks make great pendants, pins, hair clips, or they could be added to any number of accessories.
Step1: Make three stacks of vinyl and metal flowers in a pattern that you like. Use an awl to poke holes through the flowers that don't already have holes. Feed one head pin through a bead cap and then through the center of the small gold flower. Feed the pin through each of the vinyl flowers. In the back of the flowers trim the head pin to about 1/2". Grasp the end of the pin with round nose pliers and roll down until a coil from and tightly holds all the flowers together. Repeat with the other two flower stacks.
 Step 2: Decide were you want the flowers to connect to each other. Poke holes with the awl, make sure not to get too close to the edge as to not compromise the strength of the vinyl. Connect the three flowers stacks with two jump rings.
Step 3: Cut two 6" pieces of chain. Poke holes in the flowers where you want to attach the chain and use a jump ring to attach the chain.
Step 4: Attach the lobster claw clasp to one end of the chain using a jump ring and just a jump ring to the other.
The End!
Questions? Comments? I would love to hear from you!
This e-mail address is being protected from spambots. You need JavaScript enabled to view it
|
